The making and fastenings

To make the final garment I started with a base that I did last session and from here I adjust it that is required to my designs. 




I added the darts from top and bottom to fit around the bust and made it more fitted. This will then hold any techniques I will be using such as draping and de-constructing around the pattern.








Then I started to draped the half of the bodice with the tailored jacket. I have stitched it around the form its shape like a quilting technique. Then I draped the other side of the bodice with the black silk. 




The image above is the making of the top of my final garment. For the draping on the other side of the bodice. I used a straight stitch while scrunching the fabric forward. It has a really dramatic effect. The excess fabric will then be cut off and it is intended that this top will show the side of the waist. 



The back is all also a de-constructed tailored jacket with minimal quilting technique. As for the fastening back of the top is eyelets and a black cord. 



As for the skirt I used a vogue pattern as the base of of the skirt, this will then be pleated and added the same flower fabric accessory from the top along the bottom. 




This skirt flares at the bottom, so I had to make four and attach them all together. The fastening of this skirt will be a zipper at the back. 








These are the two fastening I have chosen which was eyelets and zipper. I had difficulty applying the eyelets bus my fabric was very thick. 




This is the lining and the front base of the skirt. I pleated the each section by 4cm and folder the skirt to make a structure. 
The image below is the whole view of the dress, I can now attached the lining and the zipper. The trail will then be hand stitched in each end of the waist.





0 comments:

Post a Comment

Powered by Blogger.

Recent Posts

Introduction

Recent Comments

Contributors

Followers